Instructions how to get Meteohub connected to AWEKAS
Since Version 2.2d Meteohub supports "Direct Link" feature of AWEKAS. This allows to report weather data into the AWEKAS weather network without placing the data temporarily on a web server, where AWEKAS has to pickup the data from time to time.
Configuration of Meteohub
1. Mark AWEKAS on the "weather network" page of the Meteohub administration web interface.
2. Insert your AWEKAS user name into the "ID" field. Place your AWEKAS password in the "Password" field.
3. Select the sensors to be used for data transmission to AWEKAS: Typically these are:
- th0 (standard outdoor sensor for temperature, humidity and dew point)
- thb0 (air pressure)
- rain0 (rain sensor)
- wind0 (wind sensor)
- uv0 (uv sensor)
- sol0 (solar radiation sensor)
If you don't have one of the sensors, simply omit it.
4. Select an interval for data transmission. Remark: The selected interval is valid for all selected weather networks.
5. Press "save" to make the settings work.
That's all.
[Blockierte Grafik: http://www.pasternak.net/pix/awekas3.png]
Settings to be done inside AWEKAS
1. Select "Meteohub Direct Link" as the mode of data transmission.
Done 
[Blockierte Grafik: http://www.pasternak.net/pix/awekas2.jpg]